49
12
COMMANDMIC II™ HM-157
12
■Set mode programming
Set mode is used to change the condition of the transceiver’s
functions and the microphone’s own functions:
Transceiver’s functions—
Scan type, Scan resume timer, Weather alert, Dual/Tri-watch,
Beep tone*1, LCD backlight*1, LCD contrast*1and Radio
PWR.
Microphone’s own functions—
Beep tone*2, LCD backlight*2and LCD contrast*2
*1For transceiver setting
*2For microphone setting
In this section, instructions are for the microphone’s own func-
tions only. Refer to pgs. 32 to 34 for the setting of the other
functions. (Some functions cannot be selected from the
HM-157.)

DDEntering Set mode

qTurn power OFF.
wWhile pushing [16•9], turn power ON.
•After a beep emission, a Set mode item appears at the channel
comment indicator.
eAfter the display appears, release [16•9].
rPush [16•9]to select the desired item, if necessary.
tPush [YY]or [ZZ]to select the desired condition of the item.
yTurn power OFF, then ON again to exit Set mode.
•Beep tone
You can select the silent operation
by turning beep tones OFF or you
can have confirmation beeps
sound at the push of a key by turn-
ing beep tones ON.
•LCD backlight
The LCD backlight brightness can
be adjusted from OFF, 1 (dark) to
7 (bright.)
• “ ” scrolls at the channel
comment indicator.
•LCD contrast
The LCD contrast can be ad-
justable in 4 levels. 1 is the lowest
contrast, and 4 is the highest con-
trast.
• “ ” scrolls at the channel
comment indicator.
Scrolls
Scrolls