Icom iPW1, iPW1EURO

2INSTALLATION AND CONNECTIONS

The control section of the linear ampliﬁer can be sep-

arated from the main body, doubling as a remote con-

troller.It can be placed on the exciter or in another

convenient place.

qDisconnect the AC power cable.

wRemove 8 screws from the sides of the linear

ampliﬁer, then lift up the top cover.

eUnplug the control cable from J3 on the MAIN unit.

rRemove 2 screws from the front panel of the lin-

ear ampliﬁer, then detach the remote controller.

(Fig. 1) Attach the dummy panel onto the space

left by the controller using the 2 screws.

tRemove 5 screws from the rear panel of the

remote controller, then remove the rear panel.

yReplace the control cable with the supplied sepa-

ration cable through the cable hole. Use the short-

er end (from the bushing) to connect to the remote

controller.

uRemove 2 screws from the cable hole cover on

the linear ampliﬁer rear panel. Insert the separa-

tion cable into the cable hole. Keep the hole cover

and screws for future use.

iPlug the other longer end (from the bushing) of the

separation cable into J10 on the JACK unit

through the cable hole. Connect the grounding

wire as shown below.Connect the control cable to

J11.

oPlug the other end of the control cable into J3 on

the MAIN unit. (Fig. 2)

!0 Replace the top cover and 8 screws.

■Separating the remote controller

Control cable

Separation cable

CONTROLLER

Longer end

(from the bushing)

Control cable (step e)(Fig. 2)

Control cable

(step i)

(Fig. 1)

JACK unit

MAIN unit

J11

Control cable

Separation cable

JACK unit

To J3

(MAIN) J10