SIMPLE INSTALLATION
Notices:
After installation, do not start the washing machine in haste. First open the tap to let the water press into the water inlet hose to check whether there is any leakage in the connectors on the both ends. When the pressure is too high, please shut the tap a little to avoid water
leakage.
The method of installation for the double water inlet hose is same.
SIMPLE INSTALLATION AND SIMPLE OPERATION
Step 6:Power source and grounding
The washing machine employs alternative current with the rated voltage and frequency. When the voltage fluctuates between 10% of rated voltage, the washing machine can work normally. A special power socket for the washing machine had better be set beside the washing machine for convenience and safety. The method of connection of the socket is as the figure below:
Notices:
Step 5:Installation of the drain hose
1.Nip the fixing ring with hand to make it loose and engaged on the drain hose and put the drain hose into the leading skirt of drain hose in the bottom of the washing machine to the end at the most (soak the head of the drain hose in warm water, it will make the engagement easy), and loose the fixing ring to let it clasp the drain hose.
Cabinet
Inner hose
Fixing ring
Drain hose
Leading ring
The socket and the grounding wire must be installed |
|
by an electrician to prevent incorrect installation or use of |
|
the socket, and to guarantee the safety of use of Rated voltage ~ | Grounding wire |
| |
electricity. |
|
The power wire of the washing machine employs Y |
|
connection and the replacement of the power wire |
|
should be carried out by professionals. |
|
No connection of the grounding wire with the neutral |
|
wire, otherwise the cabinet will be charged, which is |
|
likely to cause the danger of electric shock. |
|
Step 7:Installation of the base cover |
|
1. Slant the washing machine with angle of 45oin the direction of |
|
the arrows showed in the figure, put the side with the clasper to |
|
2.It had better put the outlet of the drain hose into the nearby drainage permanently, which can save the trouble that the drain hose has to be connected each time before use. If the drainage is far from the washing machine, it can be solved by connection of the drain hoses head with end to extend.
the washing machine and the other side to the ground, insert base |
|
| |
cover along the direction of the upper slot of the base from the |
| Slot | |
| |||
back side of the washing machine. |
| ||
2. Put the base cover straight to the point and then press the base | Base cover | ||
Hole for | |||
cover upward till there is a sound of "Gaba" and then screw in | |||
|
| ||
a |
|
| |
cabinet). |
|
| |
Simple operation
Preparations before using:
1.Hang the drain hose up, the high is about 1 m.
2.Connect the water inlet hose and open the tap.
3.Put the power plug into the socket.
4.Take out the coins and other sundries and shake off the mud and sand on the clothes.
5.Determine water level. Press "Water level" button to select the water level.
6.Press "Power" switch button.
7.Press "Start/Pause" button. The washing machine will go into operation by the automatic program of standard.
Notices:
If you want to set other programs, please see and read "Full automatic program" and
