METHOD OF MAINTENANCE
TROUBLE SHOOTING
The following cases are not faults
1.There is water injection in time of washing or rinse, which is due to that the washer senses the
inadequacy of water and exchanges water level automatically.
2.There is the phenomenon of intermittent spinning in the beginning of spinning, which is performed
to achieve better spinning effects.
3.In the course of spin, the program return to the wash program. Because that is designed to rectify the unbalanced distribution of load in the spin tub.
Exceptional
phenomenon
No indication in controller
The inlet hose
.leakage
Cause
The power plug is not plugged tight.
The power switch is not switched
on.
Not press "START/PAUSE" button.
Power cut.
Do not rightly connect the tap with
the universal connector.
Do not screw tight the nut of the
water inlet hose.
Solution
Check the power socket, or change other
socket.
Press "START/PAUSE" button.
Wait for switching on electricity.
Screw tight the nut.
Method Of Maintenance
After the whole washing program
The washing machine will send off the "DOU- DOU"sound after any program operation to remind you of taking out the load or going on with other operations.
After finishing washing, please shut off the tap, pull out the plug in case of water leakage or fire
Cleaning the water inlet
After long time use, the water inlet mesh bag may be blocked with smudginess, and should be cleaned according to the following steps:
1.Switch on the power, followed by shutting off the tap .
2.Let the washer works for 5 seconds so that water flows into the tub through the water inlet hose. then turn off the power.
3.Unload the water inlet hose and clean the mesh bag, then restore the water inlet assembly.
Maintenance of shell
Use soft cloth to wipe off the water and dirt on the surface each time after use of the washing machine. Detergent, propellant and other chemicals are not allowed to use, for they can cause damage to the surface.
Cleaning of the lint filter
A f t e r u s i n g t h e |
| ||
washing machine for a |
| ||
period, | please clean |
| |
according the | following |
| |
steps: |
|
|
|
1. Take out the lint filter. |
| ||
2. Turn the mesh bag | Clasper | ||
outside | and | wash it | |
clean in the water.
3. Restore it and refix it.
Slot
Does not drain
Dose not inject water
Spinning stops and water injecting begains in the course of spin
Does not spin
Intermittent spinning
Before using the machine water exists in the drain hose.
Notices:
The drain hose is wrung or jammed.
Stop water.
Do not open the tap.
Whether the wire netting in the water
inlet was stopped up by the sundries.
Cause by that the washing
After end to drain, do not close the lid.
Open the lid in course of spinning.
In order to attain the better
spinning effect.
Remainning water due to testing
or experiment in the factory.
Loosen the drain hose for smooth flow of water
Wait for coming water.
Open the tap.
Clean the netting according to the method of
"Cleaning of the water inlet".
This is automatic rectification for spinning in the washing program. That the washing are too much or too little, or that the washing machine is not placed plane will cause the unbalance in time of spinning. If there is still abnormal circumstances after checking the
Close the upper lid.
Belong to the normal phenomenon generally.
Belong to the normal phenomenon generally.
The washing machine does not work normally because the voltage is low or too high. Please pull
out the plug and wait till the voltage becomes normal.
If there is still abnormal circumstances after checking the
the plug. Do not repair it by yourself at home, which is very dangerous.
15 | 16 |
