iHome IH52 manual Using The Remote Control Unit, Install/Replace the Remote Control Batteries

Using The Remote Control Unit

Install/Replace the Remote Control Batteries

The remote control batteries are already installed at the factory. When the remote control stops operating or its range seems reduced, replace the batteries with new ones.

1.The battery door is located on the back end of the unit.

2.Press to release the battery door latch.

3.Insert 2 “CR2032” 3-volt lithium batteries. Make sure the polarity (the + and – side of the battery) is correct.

4.Replace the battery holder back in the remote control.

NOTE: PLEASE DISCARD BATTERIES PROPERLY

CHANGING THE REMOTE CONTROL CODE

Battery door

DIP switches

Install Remote Control Battery

The iH52 has 4 DIP switches located in the backup battery compartment (see page 11) and in the remote control battery compartment. If you experience interference from other remotes or have more than one iH52 operating at once, you may need to change the DIP switch settings (DIP settings on remote and base unit must always match). To do so:

a)Open the battery compartment on both the remote control and the iH52.

b)Check that all DIP switch positions on unit and remote control match

c)Use fingernail or small object such as a paperclip tip to move ONE of the switches on the base unit to a different position. Do the same on the remote, making sure to move the same switch to the same position so the switches on

each match.

d)Test performance. If interference is still an issue, adjust DIP switch settings again.

OPERATING THE REMOTE CONTROL

The Remote Control controls basic functions on the iH52 and certain iPod® functions when the iPod® is docked in the iH52. For best results, aim remote control towards the receiver.

mute

iPod/	radio
aux

eq/

dimmer display presets

Power On/Off Button: Turns iH52 ON or OFF

Play/Pause Button : Plays track. In play mode, press to pause

Select Down/Rew Button: Skip to previous or next track when iPod is playing, or HOLD to scan current playing track Aux/iPod/Shuffle Button: Select Aux, iPod or Shuffle mode Settings Button: Selects EQ and dimmer settings

Display Button: Selects standard or extended display modes

Mute Button: Toggles sound ON or OFF

Volume + Button: Raises volume level

Select Up/FF Button: Skip to previous or next track when iPod is playing, or HOLD to scan current playing track. Volume – Button: Lowers volume level

Radio Button: Play radio, select AM or FM band

Preset Button: Selects/sets up to six AM or FM station presets

12