Troubleshooting
Symptom | Possible Problem | Solution |
Unit not responding | AC adaptor isn’t plugged to a wall outlet |
(no power) | or the connector is not plugged into the |
| power supply jack on the back of the unit |
Make sure the AC adaptor is plugged into a working AC outlet and connected properly to the back of the iH80. If the outlet is controlled by a switch, make sure the switch is on
| Wall outlet is not functioning | Plug another device into the same outlet to confirm the | |
| outlet is working | ||
|
| ||
|
|
| |
| Batteries are weak | Replace with new batteries | |
|
|
| |
| Batteries were not installed properly | Check to make sure the polarity ( + and – ends) matches | |
| the diagram in the battery compartment | ||
|
|
| |
iPod does not dock | Using no insert or wrong iPod insert | Make sure the dock insert is the proper fit for your iPod | |
| Remove your iPod from the dock and check for | ||
properly | iPod not docked properly | ||
obstruction on the connectors in the dock and on your | |||
|
| iPod. Then reseat it in the dock. | |
iPod does not | iPod is not installed properly | Remove your iPod from the dock and check for | |
respond to the unit |
| obstruction on the connectors in the dock and on your | |
|
| iPod. Then reseat it in the dock. | |
| Your iPod software is too old | Upgrade software on your iPod. For details visit | |
|
| http://www.apple.com/ipod/download | |
|
|
| |
| iPod is locked up | Please make sure your iPod is working properly before | |
|
| docking into the unit. Please refer to your iPod manual for | |
|
| details. |
Using 1st or 2nd generation iPod or other devices.
iH82 cannot control those iPods or other devices.
8