iHome iH9 manual Using The Remote Control Unit, Install/Replace the Remote Control Batteries

Using The Remote Control Unit

The Remote Control controls basic functions on the iH9 and certain iPod® functions when the iPod® is docked in the iH9. For best results, use the remote control within 12 feet of the unit.

Power On/Off Alarm Reset Button: Turns iH9 ON or OFF or resets alarm when alarm is sounding

Fwd/Rev Button: Skip to previous or next track, or HOLD to scan current playing track; Also controls set wheel functions (changing settings, tuning radio, etc.)

Menu Button: Press to access iPod Menu functions

Preset Button: Cycles through AM or FM radio presets

Radio Button: Selects Radio (AM and FM radio bands) and line-in functions

EQ Button: Set Treble, Bass, 3D sound effect and Balance settings for best sound

Snooze/Dimmer Button: Snooze mode when alarm sounds, otherwise dims display

Random Button: Press for random play

Repeat Button: Press for repeat play (press again to repeat all)

Sleep Button: Press to select an amount of time before the iH9 shuts off: 120, 90, 60, 30 or 15 minutes

Volume – Button: Lowers volume level

Volume + Button: Raises volume level

Enter Button: Press to select iPod menu function

Up/Down Button: Press Up or Down to scroll iPod menu

Play/Pause Button: Plays track. In play mode, press to pause

Mute Button: Toggles sound ON or OFF

Install/Replace the Remote Control Batteries	Battery
The remote control batteries are already installed at the factory. When the remote control
	door
stops operating or its range seems reduced, replace the batteries with new ones.
1. The battery door is located on the back end of the unit.

2. Press to release the battery door latch.

3. Insert one “CR2032” 3-volt lithium batteries. Make sure the polarity (the + and – side of the battery) is correct.

4. Replace the battery holder back in the remote control.

NOTE: PLEASE DISCARD BATTERIES PROPERLY

5