Charging your iPod/iPhone and USB Device

Note: Please make sure you are using the correct insert for your iPhone/iPod and that it is properly docked into the iP39. Failure to do so may damage your iPhone/iPod.

While your iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Note that non-docking iPods will NOT charge.

Charging a USB Device

The iP39 is equipped with one USB 2.0 port (located on the the back apron) to charge most USB compatible devices such as cell phones or PDAs while the iP39 is connected to AC power.

To charge a USB-compatible device, lift the protective rubber cover from the USB port and insert the compatible USB charging cable (charging cable not included). Connect the other end to your device. Observe the charge indicator on your device to know when it is completely charged.

NOTE: Some devices specifically require a computer-connected USB port to charge

USB Mode Switch

Note: A USB Mode Switch is located on the back of the unit near the USB port. The USB Mode Switch is to address USB devices that require different bias to charge properly.

To use:

1.Connect your USB device to the USB charge port on the rear of the unit. Watch your device’s charge indicator. If it charges properly, allow it to charge.

2.If the device does not charge, move the USB Mode Switch and again observe the device’s charging indicator. If it charges properly, allow it to charge.

If your device does not charge in either of the two USB switch positions, the device may require connection to a powered USB port on a computer.

Listening to iPod/iPhone

1.Press on the slide out dock to access the dock and place the insert for your iPhone or iPod model. Gently insert an already playing iPhone or iPod. The iP39 will automatically turn on and you will hear the music playing from your iPod/iPhone.

Note: If the playing song/music loudness is too low on the iPod itself, the iP39 may not detect that the iPod/iPhone is in

play mode. Press the Button to play it. If a timer is currently active, “iPod/iPhone” “on” will be displayed for 5 sec before returning to timer display. If no timers are active, “iPod/iPhone” “on” will be displayed while in “iPod/iPhone” mode.

2.Press the or Button to change iPod/iPhone track forward/reverse.

3.When the iPhone/iPod is docked and in standby mode, press the Button to play it.

4.When the iPhone or iPod is in play mode, press the Button again to pause play; press again to resume it.

5.Press the Volume or Button to adjust the iP39 volume.

6.To turn off the unit, press the OFF button. Your iPhone/iPod will continue charging while in the dock.

Note: While listening to iPod/iPhone, if iP39 has no power (AC adaptor not plugged in) the iPod/iPhone will POWER OFF.

6

Page 8
Image 8
iHome IP39 manual Charging your iPod/iPhone and USB Device, Listening to iPod/iPhone, Charging a USB Device