Using The Optional Remote Control Unit, Battery Compartment

Using The Optional Remote Control Unit

Remote not included

with all iP41

models.

To order a remote,

please visit

www.ihomeaudio.com

Power Button turns unit ON and OFF

Volume Buttons raise and lower volume on the unit.

Pressing FWD/REV while iPhone/iPod is inserted will FWD/REV to next/previous track

Pressing and holding FWD/REV while iPhone/iPod is docked will scan forward/reverse within currently playing track.

Pressing Play/Pause from power off mode will play iPhone/iPod.

Pressing Play/Pause while iPhone/iPod is docked and playing will pause iPhone/iPod. Press again to resume play.

Pressing the mute button will mute the unit. While unit is muted the volume display will flash. Pressing mute again or volume up or down will unmute.

The up, down, fwd, rev, menu and enter buttons are used for iPhone/iPod menu navigation

The shuffle and repeat buttons will activate/deactivate the iPhone/iPod’s shuffle and repeat modes

The snooze button works exactly same as on main unit.

Install/Replace the Remote Control Battery (for models with remote control)
To order a remote control, visit www.ihomeaudio.com
The remote control battery is already installed at the factory. When the remote
control stops operating or its range seems reduced, replace the battery with a
new one.
1.	The battery door is located on the back end of the unit.
2.	Slide the battery door to release the battery door latch and remove the battery
	door.
3.	Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and –
	side of the battery) is correct.	Battery Compartment

4.Replace the battery compartment door back in the remote control.