Setting Up the iP49
Install iPod/iPhone Inserts
Your iP49 comes with a set of inserts to ensure your iPhone or iPod fits properly in the dock.
To place an insert:
1.Select the insert for your iPhone/iPod (see table on page 1).
2.Gently press the iPhone/iPod insert into the dock.
3.Carefully place your iPhone/iPod into the dock. The iPhone/iPod must not be in a case or “skin”.
4.To remove/replace an insert, first remove your iPhone/iPod then press down the insert latch, grip the insert and pull gently upwards.
Setting the Clock
Setting the Time and Calendar using iPhone/iPod Time Sync
Time sync mode allows you to sync the iP49 to the time and calendar from your iPhone or recent models of iPod like iPod Touch, iPod Nano and iPod Classic (older models such as iPod Mini do not support this feature).
1. Make sure your iPhone or iPod is properly docked. Press the Button located on the right. “SYNC” will appear on the display, indicating sync function is in progress.
2.After sync is complete, the display will show the current time and date on your iPhone/iPod clock and two beeps will confirm time sync is done.
3.If time sync fails, 2 second long beeps sound and the unit exits time sync mode. Try using a different iPhone/iPod to attempt syncing or set time manually (see below).
NOTE: The iPhone is constantly updated to current time via cell phone towers. The time on your iPod is only accurate to the last time it was synced to a computer. It’s possible to have up to 59 seconds difference between the iP49 and synced iPhone/iPod.
Setting Time and Calendar Manually
1.Set the DST Switch located on the back of the unit to +1 to add one hour or to
2.Press and hold the Button until the hour display flashes. Press the
or 
button to set the correct hour (press and hold for rapid advance). Remember to set the correct AM or PM time. The PM Indicator is located to the upper left side of the time digits; there is no AM indicator.
3.Press the Alarm Button at any time during clock setting to toggle the display between 24 hour (military) and 12 hour (standard) display mode. The PM indicator will not appear when display is in 24 hour mode.
4.Press the 
Button. The minutes will flash. Press the
or 
button to set the current minutes.
5.Press the 
Button. The year will flash. Press the
or 
button to set the current year.
6.Press the Button. The date will flash. Press the
or 
button to select the current date (press and hold to enter fast scroll mode).
7.Press the Button again (or no button press within 10 seconds) to exit the clock setting mode. 2 beeps will confirm clock setting is complete.
5
