Iiyama E2208HDD, E2208HDS user manual Connecting Your Monitor,  Fitting

ENGLISH

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off. Connect the computer to the monitor with the signal cable.

Connect the monitor to the audio equipment with the Audio Cable for computer when using the audio features.

Connect the Power Cable to the monitor first and then to the power supply. Power of the monitor and the computer is turned on.

NOTE  The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a special cable is required please contact your local iiyama dealer or regional iiyama office.

For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama office for a suitable adaptor.

Make sure you tighten the finger screws at each end of the signal cable.

[Example of Connection]

<Back>

Power Cable (Accessory)

D-Sub Signal Cable (Accessory)

DVI-D Cable (Accessory)

Audio Cable* (Accessory) Computer

* Available for ProLite E2208HDS only.

[ Fitting and Removal of Cable Holder ]

Removal

Pull out the hook.

Hold the both sides of the hook, and remove one tab at a time.

Fitting

Collect cables at the back of the stand.

Hold the both sides of the hook, and insert one tab at a time into the holes.

7 BEFORE YOU OPERATE THE MONITOR