Installing the Port cont.
To Remove Port
To remove the port lift up on each Release Button and slide the port lock away from the port.
Port Seal Inside View
If the port is installed before the camera is inserted into the housing, look on the inside of the housings at the port seal. Check to see that the o'ring is properly sealed as shown in figure 1 and not extruded as shown in figure 2.
Caution:
After installing the port, turn the Zoom Control knob on the housing. If the Zoom Control is difficult to turn, the gear sleeve may be warped. If so reduce or omit any rubber installed on the Zoom Clamp. (Fig. H on pg. 11). If the Zoom Clamp is still warped, use of the #5509.28 package may be required. (See page 7)
13
