PROBLEM: The walking belt is
SOLUTION: a. If the walking belt is
a
b.If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tight- ened, you should be able to lift each side of the walk- ing belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
b
PROBLEM: The
SOLUTION: a. Remove the key from the console and unplug the power cord.
Remove Side Shield A (60) from the right side of the treadmill by pressing down on the top of the Side Shield and then pulling it away from the Motor Hood (39). Remove Side Shield A (60) from the left side of the treadmill by pressing down on the top and then pulling it towards the Motor Hood. Next, remove the three Screws (43) from Side Shield B (59) on each side of the treadmill and remove both Side Shields.
Remove the Screws (not shown) from the Motor Hood (39). Carefully remove the Motor Hood.
Locate the Reed Switch (17) and the Magnet (12) on the left side of the Pulley (11). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8”. If necessary, loosen the Reed Switch Screw
(26)and move the Reed Switch slightly. Retighten the Screw. Reattach the Motor Hood (39) and run the tread- mill for a few minutes to check for a correct speed read- ing. Reattach the four Side Shields (59, 60).
39 |
|
60 |
|
| 59 |
59 |
|
43 | 60 |
|
1/8” | 11 | |
26 | ||
| ||
17 | 12 | |
Top |
| |
View |
|
26
