Image IMBE53910 user manual Do not tighten the M10 Nylon Locknuts 11 yet

23.Press a 50mm Square Outer Cap (73) onto each end of the Bench Base (62).

Attach the Bench Base Joint Plate (72) to the Bench Base (62) with two M10 x 70mm Bolts (91), two M10 Large Washers (58), and two M10 Nylon Locknuts (11).

Attach the Bench Leg (59) to the Bench Base Joint Plate (72) with two M10 x 70mm Bolts (91), two M10 Large Washers (58), and two M10 Nylon Locknuts (11). Be sure the welded nut is in the position shown.

Do not tighten the M10 Nylon Locknuts (11) yet.

24.Attach the Bench Leg (59) to the Bench Frame

(61)with two Thick Joint Plates (71), four M10 x 70mm Bolts (91), and four M10 Nylon Locknuts

Note: Tighten all the M10 Nylon Locknuts (11) used in steps 22–24.

25.Press two 25mm x 40mm Inner Caps (79) into each Backrest Tube (78). Press two 25mm x 40mm Inner Caps into the Backrest Adjustment Bracket (83).

Lubricate an M10 x 190mm Bolt (75). Attach the Backrest Tubes (78) to the welded tube on the Backrest Adjustment Bracket (83) with the Bolt, two M10 Large Washers (58), and an M10 Nylon Locknut (11). Make sure that the Backrest

Tubes are turned as shown. The indicated holes are not centered in the Backrest Tubes. Turn the Backrest Tubes so the holes are clos- er to the floor. Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily.

26.Lubricate an M10 x 190mm Bolt (75). Attach the Backrest Tubes (78) to the welded tube on the Bench Frame (61) with the Bolt, two M10 Large Washers (58), and an M10 Nylon Locknut (11).

Note: Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily.

23			Welded Nut
		58	59
	91		11
	62	58
73	58		72
	91	58
		73
24
91		71
			61
			71
		59	11
25	Lubricate	78	79
75		58
Holes
			11
		58
79			83
	Welded		79
	Tube
26	Lubricate
	58
75
	78		58
Welded Tube		11
	61

12