3. Make sure that a qualified electrician has wired | 3 | 3 | |
the spa to a 240 volt power source. | |||
|
| ||
Remove the two warning decals (see page 5) from |
| Fill to here | |
| 22 | ||
the spa shell. Using a damp cloth, wipe the spa shell |
| ||
|
| ||
clean. Before filling the spa, make sure that it is |
|
| |
in the desired position and that there is room to |
| 5 | |
easily service it. Once the spa is filled, it must be |
| ||
|
| ||
drained before it can be moved. |
|
| |
Insert a garden hose into the filter housing, and |
|
| |
begin filling the spa. Do not use soft water. The |
|
| |
spa may be filled with cold water; however, if warm |
|
| |
or hot water is used, the spa will be ready for use |
|
| |
sooner. Fill the spa until the water is at the level of |
| Garden | |
the molded fill line. Do not overfill the spa. |
| Hose | |
See the inset drawing. Set the Filter (5) and the |
|
| |
Basket (22) in the filter housing. Next, place the |
|
| |
Filter Cover (3) in the filter housing. |
|
| |
4. Pull down one of the straps on the Spa Cover (11) | 4 |
| |
and hold the Buckle (26) against one of the panels |
| ||
| Strap | ||
on the spa. (Note: To position the Buckle correctly, |
| ||
| 11 | ||
have a second person hold the strap on the opposite |
| Latch | |
side of the Spa Cover snug.) The Spa Cover must |
| ||
|
| ||
be snug. Do not place the Buckle over the |
| 26 | |
grooves between the premium cedar panels. See |
| ||
|
| ||
the inset drawing. Remove the latch from the Buckle |
|
| |
(26). Attach the Buckle to the panel with two #4 x 3/4” |
|
| |
Screws (27). |
| 27 | |
|
| ||
Attach the other three Buckles (26) to the panels in |
| Strap | |
the same way. |
| ||
|
| ||
Remove the Spa Cover (11) from the spa. |
| 26 | |
|
|
10
