Impex CB-349 manual Step See Diagram

STEP 2		(SEE DIAGRAM 2)
A.)	Connect the Front Stabilizer (#42) to the Main Seat Support (#52) and secure them with
	two M10 x ¾” Hex Bolts (#46), four ∅ ¾” Washers (#3), and two M10 Aircraft Nuts (#4).
	DO NOT tighten the nuts and bolts yet.
B.)	Connect the Main Seat Support (#52) to the open bracket on the Cross Brace (#15).
	Secure the rear hole on the bracket with one M10 x 2 3/8” Bolt (#2), two ∅ ¾” Washers
	(#3), and one M10 Aircraft Nut (#4). Secure the other hole with a 3” Lock Pin (#8). Note:
	DO NOT over tighten the nut and bolt. The Main Frame needs to pivot on this bolt in able
	to fold up the bench.
C.)	Connect one end of Diagonal Support (#43) to the Main Seat Support (#52). Secure it
	with one M8 x 2 1/8” Hex Bolt (#48), two ∅ 5/8” Washers (#21) and one M8 Aircraft Nut
	(#49). Connect the other end to the Front Stabilizer. Secure it with one M8 x 5/8” Hex Bolt
	(#20) and ∅ 5/8” Washer (#21).
D.)	Securely tighten all the nuts and bolts previously installed.
E.)	Insert 6 ½” Long Lock Pin (#53) into the hole on the Main Seat Support (52). NOTE: The
	Pin is not designed to sustain any heavy weight. Only use the pin when changing the
	backrest board to a vertical position while doing Walk-in-Squat from the rear.

DIAGRAM 2

5