Impex SM-4008 manual Diagram

STEP 2 (See Diagram 2)

A.) Do not tighten the Nuts and Bolts until instructed to do so.

B.) Insert a Guide Rod (#24) into the hole on left Base Frame (#5). Secure it with one M8 x 2 3/8” Allen Bolt (#103), two Ø 5/8” Washers (#106), and one M8 Aircraft Nut (#109). Slide the Left Lower Safety Stop Frame (#26) onto the Guide Rod, and then slide one Safety Stop Frame (#25) onto the Guide Rod.

C.) Attach the Front Left Vertical Frame (#1) onto the left Base Frame. Secure it with two M10 x 3 1/8” Allen Bolt (#98), four Ø ¾” Washers (#107), and two M10 Aircraft Nuts (#110).

D.) Attach one Upper Side Frame (#7) to the Guide Rod, Front Left Vertical Frame, and Rear Left Vertical Frame (#3).

E.) Secure the Upper Side Frame to Rear Left Vertical Frame from side with one M10 x 2 ½” Carriage Bolt (#88), one Ø ¾” Washer (#107), and one M10 Aircraft Nut (#110). Secure it from rear with one M10 x 5/8” Allen Bolt (#87) and one Ø ¾” Washer (#107).

F.) Secure the Upper Side Frame to the Guide Rod with one M10 x ¾” Allen Bolt (#90), and one Ø ¾” Washer (#107).

G.)Secure the Upper Side Frame to the Front Left Vertical Frame with one Left Chin-up Bracket (#49), two M10 x ¾” Allen Bolts (#90) and two Ø ¾” Washers (#107).

H.) Repeat B to G above to install the other side.

I.) Attach the Chin-up Bar (#30) to the Left and Right Chin-up Bracket (#49 & #50). Secure each end of Chin-up Bar with two M10 x 1 5/8” Carriage Bolts (#86), two Ø ¾” Washers (#107), and two M10 Aircraft Nuts (#110).

9

DIAGRAM 2