STEP 2 (See Diagram 2)
A.) Slide both a Rubber Bumper (20) and Safety Stop (#6) onto a Guide Rod (#8). B.) Slide a Sliding Bar Catch (#5) onto the Guide Rod from the top.
C.) Insert the bottom of Guide Rod into the ring cap on the left Stabilizer. Insert the top of Guide Rod into the ring cap on top of the left Upright Beam. Use the two M8 x ½” Allen Screws (#14) on the caps to secure the Guide Rod.
D.) Attach a Safety Hook (#7) to the bracket on the Safety Stop (#6). Secure it with one M10 x 1 5/8” Allen Bolt (#26), two Ø ¾” Washers (#25), and one M10 Aircraft Nut (#24).
E.) Attach the Safety Hook into the selected hole on the Upright Beam to obtain the desired height for safety catch.
F.) Repeat Steps A, B, C and D above to install the other side.
DIAGRAM 2
5
