STEP 5 (See Diagram 5)
A.) Place a Seat Pad (#8) onto the Left Seat Support (#5). Secure the front hole on the Left Seat Support with one M10 x 3 3/8” Allen Bolt (#25), Ø ¾” Lock Washer (#29), and Ø ¾” Bent Washer (#26). Secure the rear hole with one M10 x 4 1/8” Allen Bolt (#24), Ø ¾” Lock Washer (#29), Ø ¾” Washer (#27), and Rubber Bumper (#14).
B.) Attach the Handle Cover (#10) to the tube on the Left Seat Support. Align the holes and insert the Handlebar (#9) halfway through the tube. Push two Handlebar Grips (#11) onto the tube from both ends.
C.) Repeat Procedures A & B above to install the other side.
D.) To lock the Teeter Totter while not in use, align the end of the Cable Strap to the open bracket underneath the Right Seat Support then insert the
10
