Impulse hammer drill Impulse Operating Instructions, Impulse Power & Eye Mode Button

Impulse Operating Instructions

The following section will review standard operating instructions for activating, deactivating and mode selection for the Impulse.

Activating the Impulse

To turn on the Impulse, press and hold the power button for 2 seconds. The power button is located on the back of the solenoid housing. Upon activation the Impulse will beep once and the LED light will display a slow double blink. The Impulse is now active and in Eye-Off Mode.

Deactivating the Impulse

To turn off the Impulse, press and hold the power button for 2 seconds. When deactivated, the Impulse will beep once and the LED will not flash.

Impulse Power & Eye Mode Button

Power Button

& Eye Mode

Auto Shut-Down Feature

If the Impulse is not fired for 20 minutes, it will automatically deactivate and not fire.

Low Battery Indicator

When the battery level of the Impulse drops below 6.8 volts, the marker will sound an audible beep every 5 seconds.

Setting the Vision Eye Mode

The new Vision Eye detects the dropping motion of the paintball into the Impulse’s chamber. With the Impulse in Eye-On Mode, it will only fire when a paintball has been detected by the Vision Eye and is in the chamber ready to fire. With the Vision Eye turned off, the Impulse will fire every time the trigger is pulled regardless of the position of the paintball.

To change Modes between Eye-On Mode and Eye-Off Mode, press the power button once to switch back and forth between the two modes.

IMPORTANT: In Eye-On Mode, the first shot will fire with or without a paintball in the chamber. This is to allow the Impulse to fire if a paintball was loaded into the chamber prior to the marker being turned on.

LED Display for Vision Eye Modes

Eye-Off Mode	Slow double blink every second. This is the default mode for the
	Impulse when it is activated.
Eye-On Mode	Rapid 5 blinks per second. Between shots, the LED will flash at 5 blinks
	per second if the next paintball has successfully loaded. If the next paint-
	ball has not correctly loaded, the LED will flash 1 blink per second until the
	next paintball is loaded successfully.

[ 4 ]