Turning on the Appliance
Starting a wash cycle....
1. Make sure that the plug for the appliance is inserted into |
the wall socket. |
2. Make sure that the water supply is turned on to full |
pressure. |
3. Load the dishwasher (see the section entitled, "Loading |
the Dishwasher"). |
4. Pour in the detergent (see the section entitled, "Salt, |
Detergent and Rinse Aid"). |
If you forget to load some of the dishes...
The wash cycle can be interrupted by pressing the
At the end of the wash cycle...
When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using
5. Turn the knob located on the right of the control panel in |
the clockwise direction until the number or symbol for the |
cycle setting is aligned with the reference mark (see the |
section entitled, "Wash Cycle Table"). |
6. Press the |
the
Wait a few minutes before unloading the dishwasher to avoid handling the dishes
STOP
on. At this point, the wash cycle will begin. |
Cancelling or modifying a wash cycle setting...
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Press the
and utensils while they are still hot and more susceptible to breakage. They will also dry better.
Warning:
If opening the door soon after the end of the programme,or during it, stand away from the Dishwasher, to avoid possible injury from hot steam.
Wash Cycle Adjustment Buttons
"Intensive 65°C" Button
This button (see
This is not recommended for delicate items in so far as the high temperatures could make their surfaces opaque or lighten decorative colors after repeated washing.
"Half Load "Button"
This button (see
It can be used before setting any of the wash cycles, except for the intensive cycles (if included in the wash cycle table). Please keep in mind that the amount of detergent should also be cut in half.
GB | 6 |