Indesit GB Washing Machine Personalisations, Setting the spin cycle, Setting the Delay Timer

Personalisations

Setting the spin cycle

FUNCTION buttons	If, when the appliance is switched on, the KNOB is positioned on
	a programme with a spin cycle, a fixed appears. Press button
	and the maximum spin speed allowed for the programme set
	will be displayed, and the	icon flashes. Press it again and the
	values lower until they reach OFF, which indicates that the spin
	cycle has been excluded (press it again to go back to the
	maximum value); stop on the desired speed, after approximately
	2 seconds the setting is accepted: the symbol		remains fixed.

The spin cycle setting is enabled with all the programmes except for 6 and the Draining cycle.

Setting the Delay Timer

Press the button and you will see the word OFF on the

display, while the relative symbol flashes.

Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which,

the time for the set programme appears on the display and the

symbol remains on.

If you now press the START/RESET button, the set "delay"

appears; this decreases every hour until the start of the cycle. In this phase, the "delay" can only be modified by decreasing it.

The Delay Timer regulation is enabled with all programmes.

GB

Installation Description Programmes

Setting the temperature

If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature needs to be regulated, a fixed appears. Press button and the maximum temperature allowed for the programme set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, after approximately 2 seconds the setting is accepted: the symbol remains fixed.

The temperature adjustment is enabled with all wash programmes.

Functions

To enable a function:

1.press the button corresponding to the desired function, according to the table below;

2.the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled.

Function	Effect	Comments		Enabled with
				programmes:
	Bleaching cycle	Please remember to pour the bleach into extra compartment 4		2, 3, 4,
	designed to
		(see page 8).
Stain	remove the			Rinse cycle.
		This function is incompatible with the EASY IRON function.
removal	toughest stains.
	Increases the	Recommended when the appliance has a full load or with large		1, 2, 3, 4, 7,
	efficiency of the			8, 9, 11, 12,
		quantities of detergent.
Extra Rinse	rinse.			Rinse cycle.
	This option	When this function is set, programmes 4, 5, 6 will end, with the
	reduces the	laundry left to soak (Anti-crease), and the relative button flashes:		3, 4, 5, 6, 7, 8,
	amount of	- to conclude the cycle, press the START/RESET button or the
	creasing on	EASY IRON button;		9, Rinse
	fabrics, making	- to run the draining cycle alone, set the knob to the relative		cycle.
	them easier to	symbol	and press the START/RESET button.
Easy iron	iron.	This function is incompatible with the STAIN REMOVAL function.

Detergents Precautions

Care Troubleshooting Service

7