Turning on the Appliance
First of all.
Turn on the water tap completely and press
Now the appliance is on and awaiting instructions.
Starting and selecting the cycle.
Turn the cycle selector knob "D" clockwise until the reference notch on the knob corresponds with the number or symbol for the cycle you wish to set (consult the wash cycle table on page 17, especially when first using the appliance).
If the appliance door is shut, press the Start button "R" and you will hear a beep; the cycle will start up within a few seconds.
Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights "G" which come on in sequence as the appliance is performing that specific phase of the wash cycle.
These phases are:
Cancelling or modifying a wash cycle in progress…..
Premise: You can cancel the wash cycle in progress, if it has only just started.
To modify a wash cycle, keep the RESET button "R" pressed for about 5 seconds: a prolonged beep will sound, followed by three short beeps. Indicator light "G" will turn off and at this point, all the settings will have been cancelled.
To select a new wash cycle, repeat the operations illustrated in the paragraph entitled "starting and selecting the cycle".
Warning: the knob must be turned clockwise from wash cycle 1 to 6, an
If you have left out a dish…
You can interrupt a wash cycle by pressing the
There's been a power failure? Have you opened the dishwasher door?
The wash cycle stops and then restarts when the electricity comes back on or when the door is shut.
At the end of the wash cycle….
The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light.
•Press button "A" to turn the appliance off.
•Turn off the water tap.
•Wait a few minutes before unloading the dishes: if you wait a little while, they dry better thanks to the steam.
•Empty the lower rack first.
Warning: when you open the dishwasher door after the wash cycle has just ended or is under way, take care not to scald yourself with the hot steam.
You decide when it starts.
When you have loaded the dishes, you can choose when to start your dishwasher before setting the wash cycle desired. Press button "H" to delay the start of the wash cycle by 12, 9, 6 or 3 hours. Each time you press it, you will hear a short beep and the indicator light "G" corresponding to the selected delay will come on.
Now you can select the desired wash cycle and, after you hear the beep, the countdown to the delayed start will begin.
If you have set a 12 hour delay, for example, once you have selected the wash cycle, the 12 hour indicator light will flash followed by the others in sequence until the set time delay is up. A quick look at the indicator lights will keep you informed of the countdown progress at all times.
Dual function of indicator lights "G"
1)flashing to indicate a delayed start: to remind you that you have set a delayed start;
2)on and not flashing beneath the cycle phase symbol: meaning the cycle has started and is in the phase indicated by the symbol.
Have you changed your mind?
If you change your mind, you can set a shorter time delay: press button "H" to select it. You need not reset the wash cycle.
If on the other hand you want to cancel the delay set and you want the cycle to start immediately, press button "H" repeatedly until the cycle starts and indicator light "G" corresponding to the cycle start phase comes on.
GB | 16 |
