Description of the washing machine
Control panel
GB
ON/OFF |
| TEMPERATURE | OPTION |
| |||
| buttons with | ||
button |
| Button | |
| indicator lights | ||
|
|
| |
|
|
|
|
DISPLAY
Detergent dispenser drawer
| SPIN SPEED |
WASH CYCLE | Button |
knob |
|
START/PAUSE
button with indicator light
DELAYED
START Button
Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”).
ON/OFF button : press this briefly to switch the machine on or off. The START/PAUSE indicator light, which flashes slowly in a green colour shows that the machine is switched on. To switch off the washing machine during the wash cycle, press and hold the button for approximately 2 seconds; if the button is pressed briefly or accidentally the machine will not switch off. If the machine is switched off during a wash cycle, this wash cycle will be cancelled.
WASH CYCLE knob: used to set the desired wash cycle (see "Table of wash cycles").
OPTION buttons with indicator light: used to select the available options. The indicator light corresponding to the selected option will remain lit.
SPIN button : press to reduce or completely exclude the spin cycle - the value is indicated on the display.
TEMPERATURE button : press to decrease or
completely exclude the temperature: the value will be shown on the display.
DELAYED START button : press to set a delayed start time for the selected wash cycle. The delay time will be shown on the display.
START/PAUSE button with indicator light: when the green indicator light flashes slowly, press the button to start a wash cycle. Once the cycle has begun the indicator light will remain lit in a fixed manner. To pause the wash cycle, press the button again; the indicator light will flash in an orange colour. If the symbol is not illuminated, the door may be opened. To start the wash cycle from the point at which it was interrupted, press the button again.
Standby mode
This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after a few minutes if no activity is detected. Press the
4