CLEANING AND MAINTENANCE
Disconnect your appliance from the electricity supply before carrying out any cleaning or maintenance operations on it.
To extend the life of your oven, it must be cleaned fre- quently, keeping in mind that:
•The enamelled parts and the
•The inside of the oven should be cleaned immediately after use with warm soapy water; the soap should be rinsed off and the interior dried thoroughly;
•Stainless steel may become marked if it comes into con- tact with very hard water or harsh detergents (containing phosphorous) for long periods of time. After cleaning, rinse and dry thoroughly. It is also recommended that any re- maining drops of water be dried;
•Never line the oven bottom with aluminium foil, as the consequent accumulation of heat could compromise the cooking and even damage the enamel coating.
Replacing the Oven Lamp
• Disconnect the oven from the power supply by means of |
the omnipolar switch used to connect the appliance to |
the electrical mains; or unplug the appliance if the plug is |
accessible; |
• Remove the glass cover of the |
• Remove the lamp and replace with a lamp resistant to |
high temperatures (300°C) with the following |
characteristics: |
- Voltage: 230/240 V |
-Type E14
•Replace the glass cover and
reconnect the oven to the mains power supply.
Disassembling/assembling the oven door
To make it easier to clean the inside of your oven, the oven door can be removed, by proceeding as follows (fig.
•Open the door completely and raise the 2 levers "B" (fig. 3);
•Now, shutting the door slightly, you can lift it out by pulling out the hooks "A" as shown in figure 4.
To reassemble the door:
•With the door in a vertical position, insert the two hooks "A" into the slots;
•Ensure that seat "D" is hooked perfectly onto the edge of the slot (move the oven door backwards and forward slightly);
•Keep the oven door open fully, unhook the 2 levers "B" downwards and then shut the door again.
- Power: 15W |
fig 3
fig 4
IE GB | 6 |
