Indesit PWDE 8148 S instruction manual Installation, Unpacking and levelling

Installation

	! This instruction manual should be kept in a safe place for
GB
	future reference. If the washer-dryer is sold, transferred or
	moved, make sure that the instruction manual remains with
	the machine so that the new owner is able to familiarise
	himself/herself with its operation and features.
	! Read these instructions carefully: they contain vital
	information relating to the safe installation and operation of
	the appliance.

Unpacking and levelling

Unpacking

1. Remove the washer-dryer from its packaging.

2. Make sure that the washer-dryer has not been damaged during the transportation process. If it has been damaged, contact the retailer and do not proceed any further with the installation process.

3. Remove the 4 protective screws (used during transportation) and the rubber washer with the corresponding spacer, located on the rear part of the appliance (see figure).

4.Close off the holes using the plastic plugs provided.

5.Keep all the parts in a safe place: you will need them again if the washer-dryer needs to be moved to another location.

!Packaging materials should not be used as toys for children.

Levelling

1.Install the washer-dryer on a flat sturdy floor, without resting it up against walls, furniture cabinets or anything else.

2.If the floor is not perfectly level, compensate for any unevenness by tightening

or loosening the adjustable front feet (see figure);

the angle of inclination, measured in relation to the worktop, must not exceed 2°.

Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washer-dryer.

Connecting the electricity and water supplies

Connecting the water inlet hose

1. Connect the inlet hose by screwing it to a cold water tab using a 3/4 gas threaded connection (see figure).

Before performing the connection, allow the water to run freely until it is perfectly clear.

2. Connect the inlet hose to the washer-dryer by screwing it onto the corresponding water inlet of the appliance, which is situated on the top right- hand side of the rear part of the appliance (see figure).

3. Make sure that the hose is not folded over or bent.

!The water pressure at the tap must fall within the range of values indicated in the Technical data table (see next page).

!If the inlet hose is not long enough, contact a specialised shop or an authorised technician.

!Never use second-hand hoses.

!Use the ones supplied with the machine.

2