Service Details
Post installation checks
Leak Check
Ensure all gas control knobs are in the Off position.
Ensure the gas supply is switched on.
Spray a solution of soapy water onto all gas joints as well as the full length of any flexible hoses.
UNDER NO CIRCUMSTANCES USE A NAKED FLAME IN CHECKING FOR LEAKS.
If bubbles appear anywhere, turn the gas supply off, check all connections and retest. If satisfactory operation cannot be achieved, contact place of purchase or their appointed agent for service.
Flame check
Turn each burner on, and ensure that the flame is blue with minimal yellow tipping. If there is significant yellow tipping, flame lift off or excessive noise, check pressure and adjust at the regulator if necessary.
If satisfactory operation cannot be achieved, contact place of purchase or their appointed agent for service.
Igniter operation
Check that the igniter for each burner successfully ignites the gas.
If an igniter fails to work, first remove the plug from the electrical power outlet, and then check that all the electrical connections are in place.
If satisfactory operation cannot be achieved, contact place of purchase or their appointed agent for service.
Low flame setting
Check the low flame setting for each hob burner to ensure that the minimum flame will not be extinguished by air draughts.
Light the burner.
Turn the control until it engages in the minimum position.
Ensure the flame is stable and will not be extinguished by air draughts.
To adjust the minimum flame:
Follow the procedure described in the gas conversion in- struction.
DO NOT MODIFY THIS APPLIANCE IN ANY WAY.
Electrical equipment and components
To check or replace the ignition module
Electrical components are located below the hob surface. To access the components:
IMPORTANT: First ensure that gas and electrical power are disconnected before performing any service to this appliance.
Remove the control knobs, trivets, burner caps and burner head assembly.
Invert the cooktop and remove the two screws on the base near the gas manifold.
Lift the base upwards. Take care to ensure that no dam- age occurs to the spark ignition leads or the igniter com- ponents.
The electronic ignition module is now easily accessible for service or replacement.
Assembly is a reversal of the above procedure.
To check or replace the gas controls and gas manifold
Gas components are located below the hob surface.
Access the components underneath the surface of the hob as described in the previous section.
Disconnect all ancillary gas piping, wiring and any screws, as appropriate.
The gas manifold may then be extracted.
Replacement is a reversal of the above procedure.
ALWAYS PERFORM A LEAK CHECK AFTER PERFORM- ING ANY SERVICE. Correct procedure is at the top of this page.
Adjust turn down setting
Put the tap to the low flame position;
Remove the tap knob and turn the adjusting screw, situ- ated inside the tap stem (fig.11), using a screwdriver (loosening the screw increases the height of the flame, tightening decreases it). note: the adjusting screw must be fully screwed down for liquid gas.
Having obtained the low flame setting required and with the burner lit, abruptly change the position of the knob several times from minimum to maximum and vice versa and check that the flame does not go out.
6
