Control panel

WASHING TIME INDICATOR lights

START DAILY WASH 30’

PROGRAMME button

START DELICATES PROGRAMME button

ON/OFF button

GB

 

 

DOOR LOCKED red indicator light

START WHITE COTTON PROGRAMME button

START COLOUR MIX EASY-IRON PROGRAMME button

ON/OFF button: press this to switch the machine on or off. When the machine is switched on, the buttons used to start various programmes begin to flash, while the washing time indicator lights illuminate in a fixed manner.

To cancel the cycle, press and hold the on/off button for approximately 2 seconds while the wash cycle is in progress.

The indicator light will flash for a few seconds and the machine will automatically drain the water in the tub.

DOOR LOCKED red indicator light:

when the indicator light is illuminated the door is locked to prevent it being opened accidentally; to avoid damaging the appliance, wait for the light to switch off before opening the door after the cycle has ended or when the cycle is paused. The light will remain lit for approximately two minutes after the washing programme has finished.

￿Rapid flashing of the DOOR LOCKED indicator light indicates a fault (see “Troubleshooting”).

START PROGRAMME buttons:

press one of these to start the selected washing programme.

-button lit in a fixed manner: programme in progress.

-buttons flashing: awaiting selection.

WASHING TIME INDICATOR lights: these light up in sequence to indicate the progress of the washing programme. At the end of the programme all the indicator lights begin to flash .

For further details, please refer to the chapter entitled “Running a wash cycle”.

Load balancing system

To avoid excessive vibrations before every spin, the machine distributes the load in a uniform manner by rotating the drum continuously at a speed which is slightly greater than the washing rotation speed. When, despite repeated attempts, the load is not perfectly distributed, the machine spins at a lower speed than stated for the wash cycle.

If the load is excessively unbalanced, the machine performs the distribution process instead of spinning. Balancing attempts may increase the total duration of the cycle, up to a maximum of 10 minutes.

7

Page 7
Image 7
Indesit SIXL 149 D manual Control panel, Load balancing system