Power On Self-test
The DPP350’s LF switch/button is used for entering various printer modes. These modes can be used to assist developers in debugging problems related to programming and communication. The following explain how to access the various operating modes.
Step #1: Make sure the printer is OFF
Step #2: Press and hold the line feed button (LF). While pressing the (LF) button, press the (ON) button momentarily and release when the LED turns green. Release LF button after the printer Beep once. Shortly after the LF button is released the printer will print the internal test pattern on the right.
LF Button Operation Modes
Short Push | N/A | Paper feed | |
|
|
| |
| 1 - beep | ||
Push and |
|
| |
2 - beeps | Hex Dump mode | ||
Hold - | |||
release after |
|
| |
|
| ||
the number | 3 - beeps | ||
of beeps |
|
| |
4 - beeps | Program mode | ||
| |||
|
|
|
Table 5
Note: Care must be taken when entering operating modes to prevent the clearing of factory preset configuration information.
Infinite Peripherals, Inc.
www.ipcprint.com. . . . . . . . . . . .Page. . .12. . . . .