Step 5
Place the supplied fiberglass insulation in the rear of the mounting frame. Place the cardboard shim on top of the lower front ledge of the frame, as shown. The cardboard shim is for aligning the baffle assembly properly within the speaker mounting frame. Lift the speaker baffle up and place it on the shim. Connect the speaker wires as shown on pages 9 and 10 and slide the baffle into place. Be sure that as you slide the speaker baffle assembly into place, the speaker wires are clear of the woofer basket and do not get pinched between the baffle and the mounting frame. Insert the four screws through the inserts into the holes and tighten by hand just until snug.
WARNING: If you overtighten these screws, it may cause the
“isolators” to become overcompressed and they will no longer function correctly. Maximum tightening of these screws is no more than
FIBERGLASS
INSULATION
MOUNTING FRAME | SPEAKER WIRES |
BAFFLE ASSEMBLY
CARDBOARD SHIM
SCREWS
INSERTS
REMOVE SHIM AFTER
SECURING SCREWS
CAS 3.1/CAS 2.1 | 7 |
