Infinity FIFTEEN manual Connections, Set Normal/LFE Switch to LFE, Set Normal/LFE Switch to Normal

CONNECTIONS

If you have a Dolby® Digital or DTS® receiver/processor with a low-frequency-effects (LFE) output:

SUBWOOFER OR

LFE OUTPUT

• Set Normal/LFE Switch to LFE.

NOTE: In this case, you do not need to use a Y-connector. Simply connect the LFE output on your receiver/processor to either the left or right input on the subwoofer.

If your receiver/processor has subwoofer outputs for the left and right channels:

• Set Normal/LFE Switch to Normal.

NOTE: Some receivers have a single subwoofer output (do not confuse this with a single LFE output as described to the left). In that case, it is recommended that you use a Y-connector (not included) to maximize performance.

SUBWOOFER OR

LFE OUTPUT

OR

The Cascade Model Fifteen also includes a set of line outputs. These outputs allow you to “daisy-chain” one Model Fifteen to multiple Model Fifteen subwoofers. Simply connect the first subwoofer as described above and then run a subwoofer cable from the line output(s) to the line input(s) on the next sub.

NOTE: This line output is before the R.A.B.O.S. circuit. Each sub- woofer’s R.A.B.O.S. controls must be individually adjusted during the R.A.B.O.S. setup.

3CASCADE MODEL FIFTEEN