Infinity NV29 manual To replace new Belt, ef f, Cleaning the Pet Hair Power Brush, Part

To replace new Belt:

Slide one end of the new Belt over the motor-driven shaft (e).

Slide second end of the Belt around Brush Roll (f).

ef

f

Partially insert the right end of the roller into one side holder (g).

g

Partially insert the left end into the other side holder (h).

h

Push both ends all the way into the side holders at the same time.

Center Belt on motor-driven shaft; test Brush Roll for easy turning.

Line up the 4 tabs on the Belt and Brush Roll Cover with the slots on the Power Nozzle (i); push into place.

i

Turn the three locking screws clockwise (j) to tighten.

j

Cleaning the Pet Hair Power Brush

Slide locking latch (k) forward.

Gently tilt brush housing upward to open.

IMPORTANT: DO NOT force; it will not open all the way.

k

Remove debris from turbine wheel and air passage.

Ordering Replacement Parts

To order additional parts and accessories, go to www.infinityvac.com or call

1-888-668-9600.Note: some parts may be available at your local Infinity retailer.

Part	Part No.
Motor Belt	1102-FP
Headlight Bulb	1088-FP
Foam and Felt Filters	1083-FP
HEPA Filter	1082-FP
Telescopic Wand	1121-FP
Detachable Handle	1119-FP
Super Stretch Hose	1120-FP
Upper Hose Holder	1086-FP
Crevice Tool	1084-FP
Upholstry/Dusting Brush
Pet Hair Power Brush	1097-FP
Low Reach Bare Floor Brush

www.infinityvac.com

15