Infinity OVTR 3, OVTR 2 owner manual ⁄ 8 min

Figure 2. This cross-section shows how to install a foot onto the bottom of a Compositions Overture OVTR 2 or OVTR 3 speaker.

Bottom

Of Speaker

Locking Nut

5 ⁄8" min.	5	⁄8"
	Foot

11 ⁄8" max.

round end

spike end

Nylon Dome

(optional for wood floors)

CARPETED	HARD-SURFACE
FLOORS	FLOORS

2.For carpets, screw the round end of a foot into each hole and hand- tighten a nut onto each one (see Figure 2). Leave a minimum of 5⁄8" exposed spike to keep the carpet from blocking the port. (On thicker carpets, you can increase the length of exposed spike up to 1 1 ⁄8 ").

For hard-surface floors, screw the spike end into each hole instead and leave 5⁄8" of round end exposed.

3.Carefully flip each speaker upright to sit on its feet.

4.If needed, adjust the feet so each speaker is level and then tighten each nut with the enclosed wrench. To protect hard surfaces (e.g., wood floors), thread a nylon dome onto each round end (see Figure 2).

Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual ◆ 3