Infinity TSS 3-IN-1 manual Tilting the Speaker, Step One, Step Two, Step Three

Tilting the Speaker

If needed, the enclosed stand allows you to tilt the speaker across a wide range (i.e., upward to a maximum of 18˚ or downward to a maximum of 7˚), as shown in Figure 3.

Important!

Do not exceed the tilt range. Doing so may cause the speaker to fall out of its stand.

Figure 3.

Wall-Mounting the TSS 3-IN-1 Using the Included Wall Bracket

The customer is responsible for proper selection and use of mounting hardware, and for correctly and safely wall-mounting the speakers.

Step One

Remove the wall bracket cover by removing the four wall-bracket screws on the ends, as shown.

Step Two

Run the speaker wire for the left, center and right channels behind the wall bracket and out the holes in the bracket. After deciding where to place the speaker, attach the wall bracket (in a horizontal position) to the wall using the appropriate screws and anchors.

Wall bracket

Mounting screws and anchors not included

Step Three

Run the speaker wires out through the holes in the wall bracket cover. Resecure in place, as shown, with the four wall bracket screws.

TSS 3-IN-1 3