WIRING THE SPEAKER
After placing the speaker, you are ready to connect it to your system. First, turn off all audio system power. Use
Surround Modes
When using the TSS
Wiring and Polarity
The TSS
+terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown in Figure 4. Connect the – (black) terminals in a similar way. See the owner’s manuals that were included with your amplifier or receiver to confirm connection procedures.
Be sure to connect the
Important!
Do not reverse polarities (i.e., + to – or – to +) when making connections. Doing so will degrade the imaging and bass response of the home theater system.
After correctly placing and wiring the TSS
2 1
One channel shown.
–+
Figure 4. This example shows how to connect bare wires to the terminals. Banana plugs may also be inserted directly into the rear of the connector.
1Loosen the terminals.
2Insert bare ends; tighten terminals.
CARE OF YOUR SPEAKER SYSTEM
When needed, use a soft cloth to remove any fingerprints or to wipe off dust. Do not use any cleaning products or polish. Clean the grille by gentle vacuuming.
If your TSS
TSS | 5 |