A t t a c h t h e M o u n t i n g P l a t e t o t h e P r o j e c t o r

CAUTION: Use only the hardware that is provided with the LP 740 Ceiling Mount. Using different hardware may damage your projector.

Attach the Mounting Plate to the Projector

1Set the projector on a table with the bottom side up. Align the holes in the mounting plate with the holes in the projector.

2Insert the 3 screws into the 3 quick release sleeves (Figure 3).

3Loosely attach the screws and sleeves to the holes in the projector as shown in Figure 3.

4Align the keyholes in the mounting bracket with the screws in the projector. Slide the mounting bracket until the quick release sleeves are at the top of the keyhole slot.

5Attach the 5mm knurled knob to the projector in the location shown in Figure 3. Tighten the three 5mm screws and the 5 mm knurled knob. Be careful not to over-tighten the screws.

knurled knob

goes here

FIGURE 3

quick release screws

Attach the mounting plate to the projector

6

Page 8
Image 8
InFocus 740 manual Attach the Mounting Plate to the Projector