InFocus IN20 Shutting down the projector, Troubleshooting your setup, Screen Save, Power Save

Shutting down the projector

The projector automatically displays a black screen after no active source is detected for 30 minutes. This black screen helps preserve the life of the pro- jector. The image returns when an active source is detected or a remote or keypad button is pressed.

Screen Save

You can make the black screen appear after a preset number of minutes by turning on the Screen Save feature in the Settings>System menu. See page 31.

Power Save

The projector also has a Power Save feature that automatically turns the lamp off after no active sources are detected and no user interaction with the projector is performed for 20 minutes. By default, this feature is off. See page 31.

Turning off the projector

To turn the projector off, press the Power button on the remote or keypad two times (the second time verifies the shut-down request). The lamp turns off and the Power light on the Status Indicator Panel blinks green for one (1) minute while the fans continue to run to cool the lamp. While the light is blinking green, the projector does not accept any keypad and remote control input. When the lamp has cooled, the Power light is solid green.

Troubleshooting your setup

If your image appears correctly on the screen, skip to the next section. If it does not, troubleshoot the setup.

The Status Indicator Panel on top of the projector indicates the state of the projector and can help you troubleshoot.

Table 2: Status indicator light behavior and meaning

Status Indicator Panel icons	Meaning
Power, solid green	The power button has been pressed and
	the software has initialized or the projec-
	tor has been powered off.
Power, blinking green	The power button has been pressed and
	the software is initializing, or the projec-
	tor is powering down and the fans are
	running to cool the lamp.
Thermometer	The projector is too hot. Make sure the
	vents aren’t blocked (see page 20). Turn
	off the projector and wait one minute,
	then turn the projector on again. Contact
	Technical Support if the problem persists.
Lamp	Turn off the projector and wait one
	minute, then turn the projector on again.
	If the lamp light turns on again, replace the
	lamp and reset the lamp timer.
Wrench/Service	Turn off the projector and wait one
	minute, then turn the projector on again.
	If the service lamp turns on again, service
	is required. Visit www.infocus.com/service
	to contact Service.

14