1Turn off the projector and unplug the power cord.
2Wait 60 minutes to allow the projector to cool thoroughly.
3Remove the lamp door, located on top of the projector, by (a) removing the two screws on either side of the lamp door, (b) sliding the lamp door towards the front of the projector, and (c) tilting and lifting the door off.
4Disconnect the lamp connector.
5Loosen the captive screw that attaches the lamp housing to the projector. NOTE: If the projector is installed on a ceiling mount, be careful not to drop the lamp module once the captive screw is loosened.
6Carefully lift the lamp straight up, off of the alignment pins; being careful not to pinch the lamp connector. Dispose of the lamp in an environmentally proper manner.
7Install the new lamp module, aligning the pins properly. Be careful not to pinch the lamp connector.
8Tighten the screw. (NOTE: If the pins have not been aligned properly, the screw will not tighten securely.)
9
10Replace the lamp door by (a) aligning the hinges, (b) putting the lamp door down and (c) sliding it back into place.
11Replace the lamp door screws and tighten securely.
12Plug in the power cord and press the Power button to turn the projector back on.
13To reset the lamp hour timer, navigate to the Status and Service menu and select Reset Lamp Hours. See page 36 for details.
turn off and unplug | wait 60 minutes |
projector |
|
Disconnect lamp Connector
loosen screw
Status and Service
Source Info
Projector Info
LiteBoard™ Info
Reset Lamp Hours...
Factory Reset...
Service Code...
i
48
