PhotoBooth Assembly Page 5
PhotoBooth PC Module Installation
If you ordered INF-PBKit-NOMP, you will need to follow these instructions to replace your
Mondopad PC. Otherwise skip to the next section.
1. Locate the Mondopad PC module on the back of the Mondopad panel.
2. Rotate the two antenna connectors counter-clockwise and disconnect them. Set them aside
in a safe place.
3. Using the security allen wrench which was included with your Mondopad, remove the two
security screws on the top and bottom of the PC module.
4. Using the PC handle, carefully pull out the PC module.
5. Insert the new PC module and tighten the screws.
6. Re-attach the antennas.
Preparing the Flash Unit
1. Disconnect the cap from the flash unit by sliding the blue “lock” slider button to the unlocked
position and rotating the cap counterclockwise and lifting up.