InFocus LP 740 warranty Custom setup, Submenu Function

Custom setup

CUSTOM SETUP				IMAGE MODE
Menu Posi				SUB MENU
View Source		OFF	ON
Image Mode		Submenu		Rear	OFF	ON
Power Save		Submenu		Ceiling	OFF	ON
Serial Set		Submenu
Smooth Mode		OFF	ON
Remote	Wireless Wired
Save Exit				Save Exit
Cancel				Cancel
SERIAL SET				POWER SAVE
SUB MENU				SUB MENU
Band Rate		19200	9600	Power Save1	OFF	ON
Stop Bits		1 2		Power Save2	OFF	ON
Parity	NONE EVN		ODD	Power Save3	OFF	ON
Save Exit				Save Exit
Cancel				Cancel

SUBMENU	FUNCTION
Menu Posi	Adjusts the menu’s position on the screen from upper-left
	or right to lower-right or left
View Source	Displays the active source (Computer, Video, or S-Video)
Image Mode	Rear: Reverses the image for rear projection
	Ceiling: Reverses the image for ceiling-mounted projection
Power Save	Allows you to turn on and off 3 different power save modes.
	mode 1: Shuts off the lamp after 3 hours if no keypad button
	is pressed
	mode 2: Shuts off the lamp after 10 minutes if no input signal
	is detected
	mode 3: Shuts off the fan automatically 2 minutes after the
	lamp is turned off
Serial Set	Sets up transmission of input signals from RS-232 control.
	Band rate: 9600, 19200 bps
	Stop bit: 1, 2
	Parity: odd, even, no parity
Smooth Mode	Smoothes the vertical lines of the image
Remote	Indicates if the remote is wired to the projector

NOTE: Serial set is used for RS-232 control from an external device. See “RS-232 Terminal Specifications” on page 43 for details.

21