Settings menu
Audio: allows adjustments to the volume and mute, and turns the projec- tor’s startup Chime on and off.
Sources: allows you to assign a particular input to a specific source key on the remote. Also allows selection of a default Startup Source and enables or disables Autosource and RGB Video.
Sources>Startup Source: this determines which source the projector checks first for active video during
Sources>Autosource: When Autosource is not checked, the projector defaults to the source selected in Startup Source. If no source is found, a blank screen displays. When Autosource is checked, Startup Source deter- mines which source the projector defaults to at
Audio
Startup
Source
until power down.
Sources>RGB Video: check this box if you are using a DVD player with RGB output.
System>Rear: reverses the image so you can project from behind a translu- cent screen.
Ceiling: turns the image upside down for
Auto Ceiling: automatically senses when the projector is inverted and turns the image upside down. This is On by default.
Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector is powered on. This allows con- trol of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as “Searching” or “Mute”) in the
Power Save: automatically turns the lamp off after no signals are detected for 5 minutes. After 3 additional minutes with no signal, the projector pow- ers down. If an active signal is received before the projector powers down, the image will be displayed.
Screen Trigger: turns on the 12 volt DC output switch on the connector panel.
Backlight: allows you to turn off the backlighting on the keypad.
Sources
System menu
Screen Save
28
