27700B S.W. Parkway Ave.
Wilsonville, Oregon
www.infocus.com
SP-CEIL-010 DIGITAL PROJECTOR MOUNT
Installation Instructions
These are the installation instructions for your Digital Projector Mount. Included are four methods of installation.
Select the method that works best for your viewing situation. The methods are:
°Fixed Height Ceiling Installation— best for short ceilings, eight (8’) or lower
°Adjustable Height Ceiling
°
°Wall Mount
NOTE: If the required height range is greater than 12½", the optional
Before You Start the Installation
The wall or ceiling where you want to install the digital projector must be capable of supporting a weight that is five (5) times the weight of 7lbs the projector you are installing. Consult the projector’s documentation for weight specifications. If the wall, ceiling, tabletop, shelf, or floor is not strong enough to handle five (5) times the weight of 7lbs, then you must reinforce the installation environment. If you are unsure about the installation environment, please consider having it reinforced and having the projector installed by qualified personnel. Failure to do so could result in serious personal injury and damage to the projector.
To avoid personal injury, use only an approved projector mount. Using an unauthorized projector mount may lead to poor ventilation and projector failure.
When installing the projector mount, keep in mind that the projector’s focus ring is not squarely in the center of the front of the projector, but offset by several inches. Make sure that when you mount the projector you offset the installation to match the amount of inches that the projector’s focus ring is offset from the center of the front of the projector.
R
LISTED
E176225
Copyright by InFocus Corporation
Wilsonville, OR. All rights reserved
Hardware description
The Digital Projector Mount utilizes the following hardware. Note that the letters associated with the hardware on this list correspond to the letters listed in the instructions for each installation method.
A. Four (4) 6 (mm) x 10 (mm) Phillips head screws (supplied)
B. One (1) mounting bracket (supplied)
C. Digital Projector (not included)
D. One (1) Litemount Plus® assembly (supplied)
NOTE: Hardware item (E) is what secures the Digital Projector Mount to your ceiling, wall, tabletop, floor. Make sure you consult with your local hardware store staff for the type of hardware that works best for your installation environment.
E. SINGLE WOOD STUD: If mounting on a single wood stud use three (3) #14 x 2" Lag bolts (minimum) commercially available. Use the mounting points on the center of the plate as indicated in the assembly diagram.
°SOLID STRUCTURE: If mounting to a solid structure use four (4) 5/16" x 2" Lag bolts or commercially available hardware (depending on the installation requirements). Use the mounting points found on the outer points of the mounting plate as indicated in the assembly diagram.
F. Allen wrench (supplied)
1
