Operation22
Operation

Starting up the projector

1. Plug the power cord into the projector and
into a wall socket. Turn on the wall socket
switch (where fitted). Check that the Power
indicator on the projector lights orange after
power has been applied.
2. Remove the lens cover. If it is left on, it
could become deformed due to the heat
produced by the projection lamp.
3. Press Power on the projector or remote
control to start the projector. The Power
indicator light flashes green and stays
green when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to
adjust the image clearness.
If the projector is still hot from previous activity, it will
run the cooling fan for approximately 90 seconds
before energizing the lamp.
4. If you are prompted for a password, press
the arrow buttons to enter a six digit
password. See "Utilizing the password function" on page 24 for details.
5. Switch all of the connected equipment on.
6. The projector will start to search for input signals. The current input source
being scanned displays on the screen. If the projector doesn't detect a valid
signal, the 'No Signal' message will continue displaying until an input source
signal is found.
You can also press SOURCE on the projector or remote control to select your
desired input signal. See "Switching input signal" on page 27 for details.
PUSH
I
I