ARO® | OPERATOR’S MANUAL | Part No. |
| INCLUDING:OPERATION,INSTALLATION& MAINTENANCE | |
|
| September 1998 |
|
| 64661088 |
8463 Power Motor
(1500 R.P.M.)
WARNING
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Pneumatic tools should always be installed and used in accordance with A.N.S.I. B186.1 “Safety Code For Portable Air Tools.”
Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure at the air inlet of the tool.
Disconnect air supply from tool before performing mainte- nance procedures.
Keep hands, clothing and long hair away from rotating end of tool.
Anticipate and be alert for sudden changes in motion during start up and operation of any power tool.
Never exceed rated r.p.m. of tool.
Wear suitable eye and hearing protection while operating tool. Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel.
Do not remove any labels. Replace any damaged label. Use only accessories recommended by ARO.
l
l
l
l
The use of other than genuine ARO replacement parts may result in safety hazards, decreased tool performance and in- creased maintenance and may invalidate all warranties.
ARO is not responsible for customer modification of tools for applications on which ARO was not consulted.
Tool maintenance and repair should be performed by autho- rized, trained, competent personnel. Consult your nearest ARO authorized servicenter.
It is the responsibility of the employer to place the information in this manual into the hands of the operator.
For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the
ARO Tool Products
1725 U.S. No. 1 North l P.O. Box 8000 • Southern Pines, NC 283884000
ARO
© 1998
