SPINDLE SECTION
DISASSEMBLY
a.Remove driver (43163) from spindle. Tap end of spindle with a soft face hammer to loosen and remove spindle out nose end of housing.
ASSEMBLY
a.Assemble felt seal (44606), wave washer (43150), bearing (42516)
(44605) and bearing (33237) to housing.
b.Assemble spindle to housing and assemble driver (43163) to spindle.
c.Assemble “O”ring
|
| MOTOR SECTION |
|
| INSTALL WITH SHIELDED SIDE OUT & |
END PLATE 43184 CYLINDER 43152 | 7 | OUTSIDE OF INNER RACE PRESSED |
FLUSH WITH END OF ROTOR | ||
1 |
|
|
BEARING 42515 | SPACER 43149 J |
|
|
ROTOR 43148 | PLATE 43185 |
| |
INSTALL WITH SHIELDED SIDE OUT |
| ||
|
| ||
| BLADES (4) | WAVY SPRING |
|
|
| BEARING 42516 | I |
|
| WASHER | |
|
|
| |
|
| * |
|
|
| * ASSEMBLED WITH GRADE A LOCKTITE |
|
MOTOR ASSEMBLY 43180
DISASSEMBLY
a.Grasp cylinder (43152) in one hand and tap threaded end of rotor with a soft face hammer; motor will come apart.
b.NOTE: Screw
ASSEMBLY
a.Assemble wavy spring (43150) and bearing (42516) to end plate (43185). Assemble bearing to end plate with shielded side out.
b.Assemble end plate (43185) to rotor and secure with washer
c.Assemble cylinder over rotor to end plate and assemble blades to rotor.
d.Assemble bearing (42515) to end plate (43184), with the shielded side out, and assemble end plate over spacer (43149) to cylinder, aligning pin in cylinder with slot in end plate.
e.Assemble collet body or driver (43162) to rotor.
8