LUBRICATION
General
Thread lubricant or an
Gear
Remove prevailing torque type nut (60) on side of hoist opposite hand lever and remove gear case assembly (1). Remove old grease and replace with new. For temperatures
Load Chain
WARNING
•Failure to maintain clean and well lubricated load chain may result in chain failure causing injury, death or substantial property damage.
1.Lubricate each link of chain weekly. Apply new lubricant over existing layer.
2.In severe applications or corrosive environments, lubricate more frequently than normal.
3.Lubricate hook and hook latch pivot points with same lubricant used on load chain.
4.To remove rust or abrasive dust buildup, clean chain with an acid free solvent. After cleaning, lubricate chain.
5.Use Ingersoll Rand
TROUBLESHOOTING
This section provides basic troubleshooting information. Specific causes to problems are best identified by thorough inspections performed by personnel instructed in safety, operation and maintenance of this equipment. The chart below provides a brief guide to common hoist symptoms, probable causes and remedies.
.
SYMPTOM | CAUSE | REMEDY |
Hoist will not hold | Brake may be slipping. | Inspect and adjust or repair as described in “INSPECTION” and “MAINTE- |
rated load. |
| NANCE” sections. |
Hoist will not lift | Excess slack in load chain. | Pull down on load chain while ratcheting until slack is removed and hoist |
load. |
| begins lifting load. Refer to “OPERATION” section. |
| Hoist is overloaded. | Reduce load to within rated capacity. |
| Hoist is in NEUTRAL (N) mode. | Ensure selector lever is in UP position. Refer to “OPERATION” section. |
Load chain binds. | Damaged load chain, pinion shaft, gears | Disassemble and inspect components as described in “MAINTENANCE” |
| or sheaves. | and “INSPECTION sections. |
| Load chain not installed properly | Inspect and adjust or repair as described in “INSPECTION” and “MAINTE- |
| (twisted, kinked or “capsized”). | NANCE” sections. |
Load hook latch | Latch broken. | Replace hook latch. |
does not work. | Load hook bent or twisted. | Inspect load hook as described in “INSPECTION” section. Replace if |
|
| necessary. |
Hoist will not free | Brake is set. | Rotate free chain knob counterclockwise. Refer to “OPERATION” section. |
chain. |
|
|
8 | MHD56109 - Edition 9 |