4
Inside the hull installations require no holes be drilled into the boat and
through experimentation, high-speed operation comparable to transom
mounting can be achieved. Two part, slow cure epoxy is required to glue
the transducer in place.
ALTERNATE TRANSDUCERS AND MOUNTING METHODS
The 350TX comes with everything necessary for installation and operation
on most boats. However, there are several situations which may require a
different type of transducer. Inboard boats, wood or metal hulls, and sail
boats create unique transducer mounting needs. Alternate transducers and
mounting methods are detailed below.
Portable Mounting
The standard transducer can be adapted for
portable installations using part number MHX-
PT2. This accessory adapts your transducer to a
suction cup mount for temporary installation on
the boat hull or other surface.
Trolling Motor Mounting
The standard transducer can also be adapted to
mount on most trolling motors using part number
AD-STM-7. This accessory includes a bracket and
hose clamp that allows mounting the transducer
to the body of most trolling motors.
Thru-Hull Mounting
Thru-hull transducers install through a hole
drilled in the hull of the boat. Larger boats or
boats with inboard motors create turbulence
that make transom mounting ineffective. Also,
hulls that are very thick or are double layered, or
made from materials such as wood or metal,
(which do not conduct sonar signals) make
inside the hull mounting inadvisable.
INSTALLATION PREPARATION
ALTERNATE TRANSDUCERS AND MOUNTING METHODS