Insignia 450TX manual What YOU see ON-SCREEN, Feature Memory, What You See On-Screen

USING THE 450TX

WHAT YOU SEE ON-SCREEN

FEATURE MEMORY

If your 450TX is installed with a transducer connected, any changes you make to the set-up or User Options (see Control Functions) while in Simulator are retained in the unit’s memory. This allows you to use simulator to experiment with the various set-up options, and retain your selected settings for normal operation.

If you are using the 450TX in Simulator when no transducer is connected, any selected options are lost when the unit is powered off. The 450TX will return to Factory Settings, or options selected when last used with a transducer, if no transducer is connected.

IMPORTANT: A transducer must be connected to the 450TX in order to retain user settings selected when in simulator mode. If no transducer is detected, the unit defaults to pre-selected options when powered off.

What You See On-Screen

Your 450TX uses a 160 x 160 matrix FSTN LCD display. This display provides outstanding viewability in all light conditions over a wide range of temperatures.

At initial power-up, the 450TX uses settings that were set at the factory. After initial use, the 450TX will remember the settings you enter.

Figure A

There are several elements on-screen that are common to all modes of operation.

Temperature/Speed. The initial screen layout takes one of two basic forms depending on whether the optional Temp/Speed accessory is installed. Figure A shows the default view when the Temp/Speed accessory is

8