Insignia IS-PA040718 CHANGING THE CORD ORIENTATION Optional Type 1 or, Listening With Earphones

Models: IS-PA040718

1 9
Download 9 pages 39.65 Kb
Page 4
Image 4
CHANGING THE CORD ORIENTATION (Optional Type 1 or 2)

CHANGING THE CORD ORIENTATION (Optional Type 1 or 2)

LISTENING WITH EARPHONES

(Type 1)

1.Remove the two large flathead slot- ted screws with a coin.

2.Gently remove plastic plate to ex- pose the cord.

3.Gently lift the cord and reroute to rear edge. Be sure to insert cord in the appropriate restraining channel.

4.Reattach the plastic plate, reinsert the two screws, and retighten screws.

(Type 2)

1.Gently pull out the plug that was origi- nally plugged into the corner of cassette.

2.Insert the plug into the jack perpen- dicular to the jack which the plug was removed.

3.If it is difficult to insert the plug into the jack rotate the plug until it fits the cassette corner properly.

LISTENING WITH EARPHONES OR HANDLING COMPACT DISCS

Connect the plug of the stereo earphones into the PHONES (GREEN) socket.

Caution: Avoid excessive volume level and lis- tening to sound for a long period of time when using earphones.

"Adjust volume to the desired level.

HANDLING COMPACT DISCS

This unit is designed to play only compact discs bearing the identification logo below.

Other discs may not conform to the CD stan- dard and may not play properly.

! Dirty, scratched or warped discs may cause

skipping or noise.

! Handle the disc only by the edges. To keep

clean, do not touch its surface.

! Discs should be stored in their cases after use

to avoid serious scratches.

! Do not expose disc to direct sunlight, high

humidity, high temperature, dust, etc. Pro-

longed exposure to extreme temperatures can

INSERT WITH THE LABEL FACING UP.

PRESS THE DISC GENTLY TO INSERT IT.

PRESS THE CLAWS

AT THE CENTER OF

THE DISC CASE.

LIFT OUT WITHOUT

TOUCHING THE

RECORDED SURFACE

INCORRECT

LISTENINGINTHECAR

1.Plug the cord into the HEAD- PHONES jack.

2.Insert the cassette adapter into the deck’s cassette slot.

Type 1

Type 2

6

warp the disc.

! Do not stick or write anything on either side of

disc. Sharp writing instruments or the inks used

in some felt tip pens may damage its surface.

Remove the disc

Hold the edge and gently press the center pivot as illustrated to pick up the disc.

CAUTION:

Wait for the disc to stop rotating before pressing the OPEN button.

Note: This unit can play 3” (8cm) single CDs without an adapter. Do not use a CD single adapter for these discs.

7

CORRECTINCORRECT

FROM THE CENTER TO THE EDGE

Page 4
Image 4
Insignia IS-PA040718 CHANGING THE CORD ORIENTATION Optional Type 1 or, Listening With Earphones, Handling Compact Discs