Connecting the power
To connect the power:
•Connect the power cord to the power jack on the back of your TV, then connect the other end to a surge protector or power outlet. If you are using a surge protector, make sure that it is turned on.
Cautions
•Make sure that you use the correct type of power. See the label on your TV.
•If you do not intend to use your TV for an extended period of time, turn off the surge protector (if you are using one) or unplug the power cord from the power outlet.
Installing the ferrite core
The ferrite core shields cables from interference. You can use the core with any cables.
To install the ferrite core:
•Open the ferrite core, clip the core around a cable near the plug, then close the core.
50 mm
Connecting a cable or satellite box
Many cable or satellite TV boxes have more than one connection type. To get the best video, you should use the best connection type available. For more information, see “What connection should I use?” on page 10.
Using HDMI (best)
To connect a cable or satellite box using HDMI:
1Turn off your TV and all connected equipment.
2Connect the cable from the cable wall jack to the
3Connect an HDMI cable (not included) between the HDMI IN 1(DVI) or HDMI IN 2 jack on the back of your TV and the HDMI jack on the cable or satellite box.
Back of TV
HDMI cable
Cable or satellite box
4Turn on your TV, then turn on the cable or satellite box.
5Go through the setup wizard on page 20.
Note
An HDMI cable carries both audio and video. You do not need to use any audio cables.
www.insigniaproducts.com | 11 |